PRODUCTS

Page view：

Product name

Cable assembly with slid-on silicone boot, weatherproofing shroud for 1/2 jumper cable with 4.3-10 male connector

Part No.:

JC12-4310MM-SB

Quantity

Inquiry

Product description

Cable assembly with slid-on silicone boot, weatherproofing shroud for 1/2" jumper cable with 4.3-10 male connector

Description.

Jumper cables are mainly used between main feeders and antennas or between main feeders and system equipment. Jumper cables are used in areas that require extremely small bending radius. Jumper cable is premium soldered, premium molded in factory, assembled with fully soldered connectors. The use of jumpers provides greater flexibility, reduced mechanical stress on antennas and connectors and better accessibility of feeder terminations. Jumper cables offer outstanding electrical performance along with high durability for superior environmental sealing for long life reliability.

Features/Benefits.

Silicone boots are one of weatherproofing solutions for the cable connection.

Silicone boot is pre-installed on the cable, simply slide the boots up the cable and over the connectors, so install faster and simple.

Boots are manufactured from a highly UV resistant silicone rubber.

Production Information.

Item No.: JC12-4310MM-SB

Cable type: 1/2"

Cable length: customizable

Connector A: 4.3-10 male

Connector B: 4.3-10 male

Silicone boot: included

Interface
According to	IEC 61169-54
Electrical
Impedance	50 ohm
Frequency	DC-6GHz
VSWR	(DC-3GHz)≤1.08
VSWR	(3-6GHz)≤1.12
PIM (@2-tone×20w)	≤-160dBC
Dielectric withstanding voltage	≥2500V RMS, 50Hz, at sea level
Dielectric Resistance	≥5000MΩ
Center contact resistance	≤1.0m Ω
Outer contact resistance	≤1.0m Ω
Mechanical
Mating cycles	≥500 times
Watertightness (1m, 1hour)	IP68
Rosh-compliance	complianced
Temperature range	-40℃~+85℃
Material and plating
Body	Brass / Tri-alloy plating
Center conductor	Phosphor bronze or bbrass/ Ag plating
Dielectric	PTFE
Gasket	Silicone rubbber
Other	Brass / Ni plating